The Siser 3D Techno® flex film increases it's volume whilst pressing causing a great 3D effect. The effect is unique to the Siser 3D Techno®. The polyester carrier is non-sticky.
Instructions
Prepress garment for 2 - 3 seconds at full temperature before positioning the film. Wash inside out, wait 24 hours after the heat transfer.
 140 °C |
 20 sec. |
 Approx. 2 bar |
 Warm |
 No |
 40 °C |
 No |
These instructions are based on the values obtained from practical experience. No responsibility is taken for the correctness of this information. We strongly recommend the evaluation on test material.
Terug naar overzicht